Well, I am in the middle of something and don’t want to start any big projects until I know how it is going to turn out. So while I wait, I decided to do some “clean-up” work on the out feed table. I flush mounted the light switch I am going to use to power the router table.
It is just a simple light switch box with standard male and female plugs at the ends. Plug power into one end and the router into the other. Used an old extension cord for the cable.
Also move one of the roll around cabinets to the router side and put pulls on the drawers. It will house the routers and all the router gear.
Lastly, went ahead and put drawer pulls on the front roll around cabinet. Among other stuff, it will hold the table saw gear.